ONEPWR SmartWash
      Back to home
      1. Hoover Support Library
      2. Troubleshooting
      3. ONEPWR SmartWash

      ONEPWR Smartwash - Brush roll not spinning

      This article contains information on how to fix Brush roll issues on the ONEPWR Smartwash.

      BH50700V_ONEPWR_SmartWash_Hero_2-1

      TIP: Make sure the unit is reclined, the brush roll won't spin in the upright position.

      tilt1

      TIP:  Your Brush roll stall might be on, this happens when your brush roll gets jammed. Turn the unit OFF for a moment then turn it back ON. If the brush roll continues stuck see the steps below.

      If your Smartwash Brush roll is not working, follow the following steps:

      1. To access the brush roll, remove the nozzle from the unit by pulling up on the latch and pulling forward

      2. Grab the Brush roll side with the notch (A) and pull up to remove. Repeat this process on the second brush roll
        Nozzle1-1br1

      3. Remove any tangled debris and clear the brushes under running water.
      4. To replace the brushes in the unit, align the other side of the brush roll to the drive gear. Then press tab (A) down until it snaps in place. 
      5. Once done replace the nozzle by lining up the two tabs on the base of the nozzle with those on the unit and rock the nozzle back into place.
        br3 placenozzle3

      NOTE: If you have tried to troubleshoot and need to fill a warranty claim, please visit our Warranty Information page for more information on how to do so.