Corded StreamLine
      Back to home
      1. Hoover Support Library
      2. Troubleshooting
      3. Corded StreamLine

      Corded Streamline - Not Dispensing

      This article contains information on how to fix dispensing issues on the Corded Streamline.

      1.FH46010V_Streamline_CordedATF_Hero

      Fillin clan tank



      NOTE:       To get optimal cleaning, remember to mix the indicated amount of Hoover cleaning solution inside the clean water tank.

      Power switch

      TIP: Make sure you are in the correct mode for what you are cleaning. The Mode Selector will change between HIGH for large messes and ECO for extended run time.
      SelfCleanButton

      Position 2-1



      NOTE:       Make sure to recline your unit and press your dispensing trigger. Release the trigger to stop dispensing

      Follow these steps if your unit is not dispensing 

      1. Once you have verified your clean water tank is properly filled, make sure it is sitting correctly in the unit. Align the bottom of your tank with the unit then rock it into place.
        clean tank
      2. If your unit continues not dispensing, you can add hot water to your clean water tank. Run your unit with hot water for a couple of minutes to help remove any build-up gunk inside the nozzle distributor bar.
      3. Lastly, remove the nozzle by pinching the latches above it and pulling out. Check for any debris or clogs on the distributor bar located behind the brush roll. Rinse your nozzle to clear out any debris as well.Nozzle 1-4brushrollBrushroll 1-2Nozzle 2-1-1

      NOTE: If you have tried to troubleshoot and need to fill a warranty claim, please visit our Warranty Information page for more information on how to do so.