PowerDash Pet+
      Back to home
      1. Hoover Support Library
      2. Troubleshooting
      3. PowerDash Pet+

      PowerDash Pet+- Not Dispensing

      This article contains information on how to fix dispensing issues on the PowerDash Pet+

      FH50704FDI_PwrDshPet_ATF_1_Hero

      Handle


      NOTE: Your unit's handle needs to be properly installed for the                    dispensing trigger to work. Install by pushing the handle base into the unit, you will hear a click once each end locks.

      tilt unitCONSEJO: Asegúrese de que la unidad esté reclinada; el cepillo giratorio no gira en posición vertical. Pise el pedal "1" para inclinar la unidad hacia atrás.Pedals

      TIP: Make sure your clean water and cleaning solution tanks are filled to the correct measure.

      My unit does not dispense water or solution.

      1. Once you have verified your tank is properly filled, make sure it is sitting correctly in the unit.
      2. If your unit continues not dispensing, add hot water to your clean water and solution tank. Run your unit with hot water for a couple of minutes to help remove any build-up gunk inside the nozzle distributor bar.
      3. Lastly, remove the nozzle by pulling the latch to unlock it and check for any debris or clogs on the distributor bar.

      Nozzle-1

      NOTE: If you have tried to troubleshoot and need to fill a warranty claim, please visit our Warranty Information page for more information on how to do so.