This article contains information on how to fix Brush roll issues on the PowerDash Pet.
TIP: Your Brush roll stall might be on, this happens when your brush roll gets jammed. Turn the unit OFF for a moment then turn it back ON. If the brush roll continues stuck see the steps below.
If your PowerDash Brush roll is not working, follow the following steps:
-
To access the brush roll, remove the nozzle from the unit by pulling up on the latch and pulling forward. Then lay your unit on the floor so you can access the bottom of it.
-
Lay your unit on the side to access the bottom of it. Use a scredriver to remove the bottom 6 screws that cover the brushroll.
- Remove the underside belt cover then pull the brush roll out and remove the belt from around it.
- Rinse the burshroll and cut free any tangles it may have. Once done place the belt around the brushroll and pivot it back into position by aligning the notches properly.
CAUTION: If you smell a burnt smell, there might be an issue with your belt. Turn OFF your unit and follow the next steps.
Follow these steps if your belt is damaged or broken
- Following the previous steps, slide the damaged belt off the shaft and replace it with a new one.
- Once you have properly placed the belt on the motor shaft, slip the brush roll through the belt.
- Position the non-belt side end cap of the brush roll into its place in the unit, then carefully stretch the belt until the other side of the brush roll fit properly into place.
- Lastly, reattach the belt cover and the 6 screws back in the unit.
NOTE: If you need a replacement belt, the part number is #440014074
NOTE: If you have tried to troubleshoot and need to fill a warranty claim, please visit our Warranty Information page for more information on how to do so.