PowerDash GO
      Back to home
      1. Hoover Support Library
      2. Troubleshooting
      3. PowerDash GO

      PowerDash GO - Not Dispensing

      This article contains information on how to fix dispensing issues on the corded PowerDash GO

      FH13010_7_ATF_Walkaround

      rig1
       


      TIP:       Before cleaning, prime the pump.  Press the dispensing trigger for 1 minute to rid any air trapped in the hose.


      TIP: Make sure your clean water and cleaning solution tanks are filled to the correct measure.

      TIP: Remember to press the handle trigger to dispense water and solution, then release the trigger to dry all the water.

      PowerDash GO does not dispense water/solution.

      1. First, confirm your clean water/ solution tank is properly placed in the unit
        CT2-2CT3-1

      2. If your unit continues not dispensing, add hot water to your clean water and solution tank. Run your unit with hot water for a couple of minutes to help remove any build-up gunk inside the nozzle distributor bar.
      3. Once you've ran your unit with warm water make sure your hose end and accessories are clean and there are no clogs.
        Tool1Tool2

      CAUTION: Sometimes the solution hose inside the hose gets kinked or pinched. Pull the hose straight to get it back to position.

      NOTE: If you have tried to troubleshoot and need to fill a warranty claim, please visit our Warranty Information page for more information on how to do so.