Floormate Jet
      Back to home
      1. Hoover Support Library
      2. Troubleshooting
      3. Floormate Jet

      Floormate Jet - Not Dispensing

      This article contains information on how to fix dispensing issues on the Floormate Jet

      BH55210_1PWR_FloormateJet_Hero-NoShdw

      TIP: Make sure your clean water tank is filled to the correct measure.
      Solution2-1

      Modes-1

       

       

      TIP: Make sure you are in the correct mode for what you are cleaning. The Mode Selector (3) will change between HIGH for large messes and ECO for extended run time. 

      NOTE: Make sure to recline your unit and press your dispensing trigger. Release the trigger to stop dispensing
      trigg

      Follow these steps if your unit is not dispensing 

      1. Once you have verified your tank is properly filled, make sure it is sitting correctly in the unit. Align the bottom of your tank with the unit then rock it into place.
        SolutionSolution 4
      2. If your unit continues not dispensing, you can add hot water to your clean water tank. Run your unit with hot water for a couple of minutes to help remove any build-up gunk inside the nozzle distributor bar.
      3. Lastly, remove the nozzle by pinching the latches above it and pulling out. Check for any debris or clogs on the distributor bar located behind the brush roll. Rinse your nozzle to clear out any debris as well.br1-1roll

      br3

      NOTE: If you have tried to troubleshoot and need to fill a warranty claim, please visit our Warranty Information page for more information on how to do so.