This article contains information on how to fix dispensing issues on the Carpet washer
NOTE: Your unit's handle needs to be properly installed for the dispensing trigger to work. Install by pushing the handle base into the unit, you will hear a click once each end locks.
NOTE: Make sure the unit is reclined, the brush roll won't spin in the upright position. Step on the pedal to tilt the unit backward.
TIP: Before cleaning, prime the pump. Press the dispensing trigger for 30 seconds to rid any air trapped in the unit, this will ensure proper dispensing of water and solution.
My unit does not dispense water or solution.
TIP: Make sure your clean water and cleaning solution tanks are filled to the correct measure.
- Once you have verified your tank is properly filled, make sure it is sitting correctly in the unit.
- If your unit continues not dispensing, add hot water to your clean water and solution tank. Run your unit with hot water for a couple of minutes to help remove any build-up gunk inside the nozzle distributor bar.
- Lastly, remove the nozzle by pulling the latch to unlock it and check for any debris or clogs on the distributor bar.
